Manual # 650338
MCL-3000 SERIES OIL PRESSURE
PART# MCL-3K-OIL
Thank you for purchasing the Dakota Digital MCL-3K-OIL gauge for your Harley Davidson Touring bike.
This gauge is designed to be a direct, plug in replacement for all touring models from 1996 and up. This
is part of a six gauge package for touring models so you can add additional gauges as you choose.
The MCL-3K-OIL gauge can be set for two stock Harley
pressure senders, ‘96-‘98 and ‘99-up
model years. There is a display update setting for how fast the numbers will change, as well as a user
settable low and high pressure warning points. When a warning condition is reached, the gauge will
flash the reading as a warning indicator. For higher pressure and more accurate pressure readings, one
of two Dakota Digital senders may be used: 0-75 psi SEN-1032, or 0-150 psi SEN-1031.
***Please read SETUP section to select correct pressure sensor for you application.
INSTALLATION
First read and familiarize yourself with all of the components and this manual. The first step is to
remove the seat and disconnect the negative side of the battery, as with any electronic install. Once the
battery is disconnected you are ready to start.
REMOVAL OF FACTORY GAUGES
Remove the outer fairing; this will vary from model to model, please follow the service manual to
expose the wiring and gauges. Don’t be alarmed by the amount of wires behind the fairing, this is a
direct plug in kit and these detailed instructions will guide you through it.
Pic of street glide with outer fairing removed Pic of road glide with outer fairing removed
All of the small gauges, fuel, volts, oil, and air temp have two plugs. One is for illumination the
other is for the gauge power, ground, and sensor signal. The illumination harness, two pins (orange and
POWER
(+12V Key ON)
GROUND
SENDER
(This terminal connects to the
stock pressure sensor or wires to
appropriate DAKOTA DIGITAL
sensor)
SWITCH/DIM PLUG
GREEN - 12V
BLUE - Dim +12V
