- 1 -
Manual #650541
CRC-1000
Drive-by-Wire Cruise Control System
Introduction
You have purchased one of the finest cruise control systems on the market. The cruise control features:
Enhanced Adaptability
•
Works with GM LS engine/trans drivetrain
•
Compact design allows for more mounting locations
•
Manual or automatic transmission capability
•
Fully plug and play design
•
Connects directly to OBD port for less wiring
Enhanced Features
•
Compact design
•
Removable wiring harness with locking device
•
Cruise engaged output (ground signal when
engaged)
Easier Installation
•
Compact module
•
Single unit mounting
•
No clutch switch needed
•
Plug and play design
•
OBD adaptable for less wiring
Kit Contents/Part numbers
Item
Qty
Description
Part #
1
1
Cruise control module
CRC-1000
2
1
Switch harness
250-XXXX
3
1
Pedal interface harness
250-2766
5
1
OBD DLC Harness
250-2785
Improved Operation
•
Closer, more accurate control of set speed
•
Accurate coast/reduce speed
•
Tap-Up, 1 MPH per tap
•
Tap-Down, 1 MPH per tap
•
Controlled resume rate
Recommended Tools
Safety glasses
Volt-Ohm meter
Soldering iron
Electrical tape or heat shrink
WARNING: DO NOT USE HAND-HELD 2-WAY TRANSCEIVERS INSIDE YOUR VEHICLE WHILE DRIVING.
WHEN TRANSMITTING FROM INSIDE THE CAR, 2-WAY RADIOS THAT OPERATE IN THE 25MHZ-700MHZ
FREQUENCY RANGE WITH MORE THAN 2.0 WATTS OF POWER CAN PRODUCE ELEC-TROMAGNETIC
INTERFERENCE THAT COULD INTERFERE WITH THE OPERATION OF CRUISE AND THROTTLE CONTROLS
RESULTING IN VEHICLE "LIMP-MODE".
USE OF CELLULAR PHONES WILL
NOT
INTERFERE WITH THESE CONTROLS.
DUE TO SENSITIVE NATURE OF SIGNALS USED FOR THIS PRODUCT, ALL NON-PLUG AND PLAY CONNECTIONS
MUST BE SOLDERED. FAILURE TO COMPLY WITH THIS REQUIREMENT WILL VOID WARRANTY.
