CY3280-SLM UNIVERSAL CAPSENSE
®
LINEAR SLIDER MODULE
KIT QUICK START GUIDE
1. Insert the kit CD in the CD drive.
2. Install the kit contents, PSoC Designer, and
PSoC Programmer.
3. The hardware prerequisites for this kit are the
CY3280-20x34* Universal CapSense Controller
(UCC) board and MiniProg1.
*
Note
The ordering part number for CY3280-20x34 UCC is
CY3280 - BK1.
1. Connect the CY3280-SLM board to the
CY3280-20x34 UCC board’s P2 connector.
2. In the CY3280-20x34 board, place the
jumper on header J1 to short pins 2 and 3.
3. In the CY3280-SLM board, place the
jumper on header J2 to short pins 2 and 3.
1. Connect MiniProg1 to the CY3280-20x34
UCC Board’s ISSP connector (J3). Connect it to
your PC using a USB cable.
2. Open PSoC Programmer and click File>File
Load. Browse and load the
CY3280_20x34_PD_Project1.hex
file*.
3. Click Connect; connect MiniProg1 to PC.
4. Click Program button to program the device.
5. Click Toggle button to power the board.
*
Note
These files are located at: <Install directory>
\Cypress\CY3280-SLM\<version>\Firmware
1. Touch and move the linear slider on the
CY3280-SLM module board. The
corresponding LEDs on the CY3280-SLM
board light up.
2. Touch a button. The corresponding LED
on the CY3280-SLM module board lights
up.
3. You can touch multiple buttons at the
same time. The linear slider and buttons can
be used at the same time.
1
2
3
4
Downloaded from
