Installation Instructions/User Manual
ELCR Series
5 AMP AUTOMATIC LOAD CONTROL RELAY
currentlighting.com/dual-lite
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 4
Rev 06/06/22
DL_ELCR_INST_R01
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS
SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
ALL SERVICING SHOULD BE PERFORMED BY QUALIFIED
PERSONNEL
• This product is intended for use with lighting fixtures controlled by an Emergency
panel. Any switching between Backup Power and Utility Power must be done
upstream of device.
• All wiring connections and mounting styles must be in accordance with the
National Electical Code (NEC), National Fire Protection Association (NFPA),
National Electrical Safety Code, state and local codes, and any other regulations
set forth by the local Authority Having Jurisdiction (AHJ).
• Per NFPA 70E, the use of Personal Protective Equipment (PPE) may be required.
Check state and local codes.
• The load’s operating voltage must be the same as the Emergency Power Input
voltage.
• To reduct the risk of electrical shock, fire, and injury to persons:
1. Disconnect all sources of power before servicing,
2. Mount this device in locations and at heights where it will not be readily
accessible to tampering by unauthorized personnel,
3. Do not mount near gas or electric heaters,
4. Do not let any wires touch hot surfaces, and
5. Do not use outdoors
• The use of accessory equipment not recommended by the manufacturer may
cause an unsafe condition.
• Do not use this device for other intended use.
