Page 3
Digital Pressure Gauge/Alarm
CruzPro
PR60
Page 14
Other CruzPro Products
l
Depthsounders & Speed/Temperature/Log
l
DC Volts/Amps/Amp-Hour Monitor
l
AC Volts/Amps//Freq/kW Monitor
l
LPG/Petrol Gas Detectors/Alarms
l
Bilge Water Alarms & Bilge Pump Controllers
l
Windlass Controller/Chain Counter
l
Digital Fuel Gauges & Fuel Consumption Calculator
l
Digital Gauges for 1 & 3 Tanks /w Separate Alarms
l
Smart and Manual Alternator Regulators
l
Marine Security System
l
RPM/Engine Hours/Elapsed Time Gauge
l
Digital Oil Pressure Gauge/Alarm
l
Digital Water Temperature Gauge/Alarm
l
One and Three Bank Digital Volts Gauges
l
Digital Amps Gauge
l
Digital Clock/Watch/Race Timers/Alarms
l
8 and 16 Amp Light Dimmers / Motor Speed Controller
l
Solar Panel Charge Controllers 6/8/9 & 20 Amps
l
4 & 8 Channel NMEA Combiners/RS-232 Convertors
l
Engine/Exhaust Temp. Monitor & Digital Pyrometer
l
Remote Digital NMEA 0183 Data Repeater
Introduction
The PR60 Digital Pressure Gauge provides an accurate
display of pressure. Pressure can be displayed up to
6550 units (PSI or Bars) or as a percentage (0 to
100%). The PR60 is pre-programmed for use with all
popular American and European resistive pressure
senders made by VDO, Teleflex, Mercury, GM,
Stewart-Warner, Centroid, Faria and others. Custom
0-5V and 4-20mA versions are also available by special
order. Low and High level alarms can be set over the
entire range of the instrument/sender. When activated,
the built-in 85 dB alarm will sound and the display will
flash. Five levels of backlighting can be selected and all
set-up, alarm values, sender type and maximum tank
capacity are saved in a non-volatile memory. The
PR60 outputs NMEA 0183 serial data or this output pin
can be programmed to activate an external alarm.
Notes
