32-PIN
(male plug)
VIDEO
CONNECTION
15 ft
(extention)
GREEN
(Parking Grid)
CONNECT TO ACTIVATE
WHITE
(Reverse Image)
CONNECT TO REVERSE
32-PIN
(female plug)
TO FACTORY
HARNESS
COMPATIBLE RADIO
BROWN/SILVER DOTS
REVERSE TRIGGER
RED/ 12V TRIGGER
BLACK/ GROUND
GREEN CONNECTOR
(at fuse panel/ driver’s left kick panel)
TAP TO ACTIVATE TRIGGER
PIN 4
(Reverse Trigger)
CONNECT FOR 12V TRIGGER
SEPERATE SCREEN
To trigger the camera when on REVERSE:
1. Tap the CAMERA POWER wire to the BROWN/SILVER wire (Pin-4)
at the driver’s side fuse panel for REVERSE power.
(See overview) TEST REVERSE BEFORE CONNECTING!
THE RADIO WILL AUTOMATICALLY DETECT THE REVERSE
GEAR WHEN ACTIVATED.
HONDA:
2011 - 2013 Odyssey EX
Note: Compatible ONLY with Odyssey Ex
vehicles with 8” Screen
RVCHN-76D
CAMERA CONNECTIONS OVERVIEW
TROUBLE SHOOTING
1. No video display while in reverse.
- Make sure the trunk is closed, as this will dis-engage the camera while in reverse.
The parking lines are there to assist you while reversing.
What the lines mean:
Yellow Line: CLEAR
Purple Line: GETTING CLOSE
Red Line: WARNING - VERY CLOSE
To remove the parking lines simply cut the GREEN wire located near
the 4 pin tail connector in the truck.
RED
PURPLE
YELLOW
We recommend reading this installation guide first before starting any
work. Following these instructions from “Start” to” Finish” will ensure
a smooth and hassle free installation. We offer telephone support M-F
9:00 AM – 5:00 PM PDT at 1 (855) 822-1348. We are here to help.
PARTS INCLUDED:
(1) Rear Camera (HN-76D)
(1) 15 ft. Extension
(1) HN-76D Harness
(1) Instruction
Camera Specifications:
- Lens Angle 170 Degrees
- Resolution 420 TV Lines
- Min. Illumination 0.2Lux
- Voltage 12v
- Operating Temp. -22˚F - 176˚F
- NTSC
- Reference Lines
- Shutter Speed 1/60s - 20us
- Waterproof
- Pixels 656 x 492
PRECAUTIONS:
- Remove the negative side of the battery to avoid any short circuits
during the installation.
- Do not install the interface near any major components or near the
HVAC system. This may cause damage or overheating to the vehicle.
- Do not disconnect the airbag connection behind the radio panel.
PRELIMINARY
:
Please read the entire manual before installing this interface.
TOOLS NEEDED:
- Drill Gun
- Panel Remover
INSTALLING THE CAMERA AND CABLE
1. Remove the rear panel with Honda emblem. Trunk lip.
2. Drill 5/8 hole in the proper location. recommend driver side of panel.
3. Insert and secure the camera using the included bolt.
4. Fish the wires through a drilled hole and through the pass through
into the trunk/cargo area.
5. Route cables to the front of the vehicle towards the factory radio.
6. Remove the factory radio to gain access to the factory display.
7. Route the wires towards the display and make the video
connection. For powering up the camera, you will need to TAP
at the fuse panel. See Overview)
8. Secure all connections and make sure to test the REVERSE gear
to power the CAMERA.
REAR-VIEW INTEGRATION CAMERA FOR HONDA ODYSSEY EX 2011-2013
PARKING LINE
CONNECTING THE REVERSE INPUT
REVERSE IMAGE
If the camera angle is inverted (upside down), please cut the WHITE
wire located near the pin tail connector in the trunk.
Rev. 112114
8” SCREEN
