Step 1. Pull out the rubber plugs from the sides of the enclosure.
Step 2. Remove the top cover of the enclosure
Step 3. Set your hard disk drive to master. Then connect the power and data cables.
Insert the hard drive back in the enclosure. Make sure the side mount holes on
the hard disk drive line up with the holes on the enclosure.
Step 4. Put the top cover back on to the enclosure.
Step 5. Secure the hard drive and the top cover with the screws.
Step 6. Put the rubber plugs back into position.
DataPortable 350 Installation Guide
Step 1
Step 2
Step 4
Step 5 & 6
