CRESTRON
CNWMBG-10A
Wall-Mount Wired Panels
R E M O T E C O N T R O L S Y S T E M S
1
DOC. 8078
Specifications subject to change without notice.
DESCRIPTION:
The CNWMBG-10A wired panel, illustrated in figure 1, interfaces with a CRESNET II control system over
the CRESNET II network. The panel uses 10 miniature pushbuttons with self-contained feedback LEDs and
includes a standard bargraph. The CNWMBG-10A is designed for wall-mounting using a standard single-
gang electrical box. Custom panel finishes, engraving, colored button caps, and the omission of unused
buttons are all standard.
1
3
5
7
9
10
8
6
4
2
CRESTRON
Figure 1. CNWMBG-10A, Wall-Mount Wired Panel
INSTALLATION/SETUP:
Identity Code
Each unique panel or component on the CRESNET II network requires the setting of an identity code (ID
CODE). ID CODES are two-digit hexadecimal numbers, from 10 to FE.
The ID CODE of the panel should be set to match the ID CODE specified in the NET.ID statement of the
CRESNET II SIMPL-C program referencing the panel (refer to SYNTAX section). To set an ID CODE,
disconnect power. Accessible through the back cover are two miniature circuit-mounted rotary
switches, identified as H and L. These 16-position hexadecimal switches can be set to 0 through F. Using
a small screwdriver, rotate the arrow in the center of the switch marked H so that it points to the first
(or most-significant) digit or letter of the specified ID CODE. Set the switch marked L to the second
(least-significant) digit or letter of the specified ID CODE.
