INS #
IB505039EN
049-290
SURE-LITES
Installation Instructions for the Sure-Lites SELDW Emergency Luminaire for
Hazardous Locations
WARNING
Risk of Fire/Electric Shock
If not qualified, consult an electrician.
WARNING
Risk of Electric Shock
Disconnect power at fuse or circuit breaker before
installing or servicing.
Important Safeguards
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE OBSERVED INCLUDING
THE FOLLOWING.
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Do not use this equipment for other than the intended use.
3. Installation is to be performed only by qualified personnel.
4. Install in accordance with National Electric Code and local
regulatory agency requirements.
5. The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
6. SAVE THESE INSTRUCTIONS
MAX MOUNTING HEIGHT: 27.6 ft.
Figure 1
Cover
Weather Shield
Backplate
INSTALLATION – HAZARDOUS LOCATIONS
NOTE:
For hazardous location compliance, the SELDW must
be installed using the provided conduit hub. The SELDW
should not be directly mounted to a junction box when
used in hazardous locations.
NOTE:
Only proceed with installation to hazardous areas
when area is non-hazardous.
1. Extend AC supply of rated voltage to conduit opening.
Leave at least 18 inches of supply connection slack. Circuit
should not be energized. Use a wiring method suitable for
hazardous location ares.
2. Remove the weather shield by removing the 4 screws in
the corners (See Figure 1). Due to the airtight nature of the
exit sign, the weather shield may be held on by a slight
vacuum. If this occurs, carefully pry the corners of the
shield with a flat head screwdriver, but do no damage the
water shield or inner gasket.
