Avoid mounting components or
routing wires near hot surfaces
Avoid mounting components or
routing wires near moving parts
Tape or loom wires under hood
for protection and appearance
Use grommets when routing wires
through metal surfaces
Use a voltmeter for testing and
verifying circuits
PROFESSIONAL INSTALLATION STRONGLY RECOMMENDED
Installation Precautions:
Roll down window to avoid locking
keys in vehicle during installation
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may cause undesired operation.
Warning!
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
CA-500 Installation Instructions
Kit Contents
(1) - CA-500 Control Module
(2) - 4 Button High Frequency Transmitters
(1) - 3 Channel Code Learning Receiver
(1) - 12 Pin Harness
(1) - 6 Pin Harness
(1) - 2 Pin Harness
(1) - 2 Pin Door Lock Harness
(1) - 2 Pin Trunk Release Harness
(1) - 4 Pin Alternate Output Harness
(1) - Control Switch
(1) - Programming Switch
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
Note:
Do not install this system on a vehicle
that is not equipped with the following:
• Automatic Transmission
• Fuel Injection
• Ignition / Shift Interlock
Technical Support
(800) 421-3209
or go to
http://techservices.codesystems.com
Summary of Contents for CA-500
Page 15: ......
