![background image](http://html.mh-extra.com/html/clinton/1095e/1095e_manual_2625286001.webp)
CLINTON INDUSTRIES, INC
207 Redneck Ave, Little Ferry, NJ 07643
PHONE: 201 440 0400 Fax: 201 440 5040
EMAIL:
Model 1095E
Air Saver, Waste Removal and Chopper
April 2006, by Peter Schueler, Clinton Ind.
Rev.: August 2006
Rev.: November 2007: 1095E01.8
Rev. July 2008 add trouble shooting to manual
Please Note (Output Venturi / Waste removal / Motor run)
To get a permanent output signal on output “WASE REMOVAL 2” while the motor
is running, set the waste removal timer to zero (0) milliseconds (parameter 4.1.4.)
To get just the venturi function, set waste removal counter zero.
To operate the venturi at the end: Parameter 4.4.3. starts the venturi. The venturi is
turned ON during stitch count of parameter 4.4.4.
Parameter 4.4.6 operates the chopper at the end
The total amount of venturi stitches has to be larger then stitches for the chopper !!
Description about:
….. Indroduction
Page 1
….. Programming
Page 2
….. Access to Hidden Parameters
Page 3
….. Master Reset
Page 3
….. Parameters (Operators)
Page 4
….. Parameters (Advanced)
Page 7
….. Built-in Test Procedure
Page 10
….. Display the Program ID
Page 10
….. Built-in Test Procedure
Page 11
….. In- and Outputs
Page 11
….. Display the Program ID
Page 12
….. Program a Memory Chip (E- prom)
Page 12
….. Trouble Shooting
Page 13
….. Photo Eye(s)
Page 17