Your SleepWeaver Advance Small Mask is attached to headgear, as shown above.
The headgear has three adjustment points—one on each side of the mask and one
on the Head Strap. A swivel connector attaches to the hose from your CPAP or
bi-level machine.
Advance
Small
Instructions for Use
SleepWeaver Advance Small - Quick Start Guide
1.
2.
3.
4.
5.
6.
7.
8.
Introduction to Your Mask
Intended Use
The SleepWeaver Advance Small Nasal Mask is intended to provide an
interface for Positive Airway Pressure (PAP) therapy. This mask is intended for
single-patient reuse in the home and in the hospital/institutional environment.
This mask is to be used on patients greater than 66 lbs (30 kg).
Fitting the Mask
1. Remove your SleepWeaver Advance Small Mask from the packaging.
2. Connect the tubing from your CPAP or bi-level machine to the Swivel
Connector on the front of the mask.
3. Turn on your CPAP or bi-level machine at your prescription pressure.
4. When the mask inflates, hold the headgear with both hands, position
the mask on your nose, and pull the headgear over your head. Make
sure that the cup of the mask is centered over your nose, and align the
Head Strap to the center of your head.
5. Pull the headgear over the back of your head until the Neck Strap is
snug just below your ears.
6. If you experience leaks, please refer to the “Adjusting for Leaks” section.
7. Lie down in your normal sleeping position. If any leaks occur, readjust the mask.
EMERGO EUROPE
Molenstraat 15
2513 BH, The Hague
The Netherlands
0459
1060 Corporate Lane
Export, PA 15632 USA
Phone: 888-825-9640 or +1-724-858-2837
www.Circadiance.com
101268 REV3
English
9.
10.
REGISTER
YOUR MASK
FOR A
CHANCE
TO WIN!
Circadiance.com/register
