Adding and Configuring the Ruggedized IP Gateway
If this CheckVideo device will be monitored by a central station, please contact the central station for a username and
password on their existing CheckVideo account. The central station will add the device to their account.
The following items can be found within the box:
•
G1002-16-XT (non-cellular)
OR
•
G1004-8-LTE (cellular services apply)
•
Power supply
•
Antenna if applicable
The Ruggedized Gateway has connectors on both sides. Only connectors shown with a red arrow are active at this time.
Other connectors are reserved for future use. Please make note of the LAN and WAN positioning. Unlike most
CheckVideo devices, this Gateway has more than one orientation.
It is critical to recognize that the WAN is the
connector closest to the side of the unit.
Back Panel:
To install the Gateway, make the following connections for the G1002-16-XT :
•
Ethernet cable to the router (WAN) and switch with cameras (LAN). If camera network is not separated, please
use the WAN port.
Note: Do not connect the CV4IP to a POE port on a router/switch. Power is provided by
the included power supply. Providing power via a POE port to the WAN connection on the device will damage
the Gateway.
•
Provided power supply to power outlet.
To install the Gateway, make the following connections to the G1004-8-LTE with on-board cellular modem:
•
Ethernet cable to the switch with cameras (LAN). The outside network connection is provided by Cellular LTE
antenna.
Note: Do not connect the CV4IP to a POE port on a router/switch. Power is provided by the
included power supply. Providing power via a POE port to the WAN connection on the device will damage the
Gateway.
•
Provided power supply to power outlet.
