background image

This kit should be installed prior to installation of your
garage door opener. Attach the extension rail after
fastening the existing rail to the power unit. See Assembly
Section of your owner’s manual, then continue with step 3
below.

In an existing installation, the trolley must be in down
(closed) position during assembly and installation. The
rail/opener assembly must be taken down and the limits
must be readjusted after re-installation.

PROCEDURE

1. Place rail/opener assembly on a flat surface.

2. Remove the rail brackets at the end of the existing rail

and set aside (Figure 1).

3. Connect the extension rail to the end of rail (Figure 2):

• Secure rails together with braces and bolts.

• Tighten all hex bolts.

4. Reattach the rail brackets to the end of the extension

rail.

5. Replace the emergency release rope that came with the

opener with the new, longer replacement rope.

6. Install the opener following the instructions in your

owner’s manual, but stop before connecting the door
arm to the outer trolley. 

7. Reposition the inner trolley as follows:

• Pull the emergency release handle to disconnect the

outer trolley from the inner trolley.

• Connect power to the opener (be sure the safety

reverse sensor is connected).

• Refer to the Adjustment Section in your opener’s

manual, and adjust the travel limits until the inner
trolley is about 3/4" (19 mm) from the rail joint
(Figure 3).

8. With the inner trolley at this new location, complete the

final Installation step in your owner’s manual to connect
the door arm and re-engage the trolley.

9. Complete all remaining adjustments of your opener,

according to your owner’s manual.

Header 

W

all

Extension Rail

Rail S

u

pport Brace

Disconnected
O

u

ter Trolley

NOTIC

E

Inner Trolley position

b

efore adj

u

stment

3/4"
(19 mm)

Inner Trolley position
after adj

u

stment

Hex Bolt
1/4-20 x 7/16"

Hex Bolt
1/4-20x7/16"

Rail Brackets 

Rail 

Figure 1.

Remove rail brackets.

Figure 3.

Reposition the inner trolley.

Figure 2.

Connect both rails.

®

OWNER’S INSTRUCTIONS

To prevent possible SERIOUS INJURY or DEATH:
• Be sure door is CLOSED and
• Disconnect power to opener before proceeding.

WARNING

CAUTION

WARNING

WARNING

Extension Rail

Rail Support Brace

Model 7806CB

EIGHT-FOOT SCREW DRIVE

RAIL EXTENSION KIT 

© 2007, The Chamberlain Group, Inc.

114A3369

All Rights Reserved

Reviews: