background image

Page 1

 

 

VENTILATION FAN 

MODEL  QTXE150

WARNING  

  

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR 

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.  Use this unit only in the manner intended by the manufacturer. 

If you have questions, contact the manufacturer at the address 

or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service 

panel and lock the service disconnecting means to prevent 

power from being switched on accidentally. When the service 

disconnecting means cannot be locked, securely fasten a promi-

nent warning device, such as a tag, to the service panel.

3.  Installation work and electrical wiring must be done by a qualified 

person(s) in accordance with all applicable codes and standards, 

including fire-rated construction codes and standards.

4.  Sufficient air is needed for proper combustion and exhausting 

of gases through the flue (chimney) of fuel burning equipment 

to prevent backdrafting. Follow the heating equipment manufac-

turer’s guideline and safety standards such as those published 

by the National Fire Protection Association (NFPA), and the 

American Society for Heating, Refrigeration and Air Conditioning 

Engineers (ASHRAE), and the local code authorities.

5.  When cutting or drilling into wall or ceiling, do not damage elec-

trical wiring and other hidden utilities.

6.  Ducted fans must always be vented to the outdoors.
7.  Acceptable for use over a tub or shower when connected to a 

GFCI (Ground Fault Circuit Interrupter) - protected branch circuit 

(ceiling installation only).

8.  This unit must be grounded.

CAUTION  

1.  For general ventilating use only. Do not use to exhaust hazardous 

or explosive materials and vapors.

2.  This product is designed for installation in ceilings up to a 12/12 

pitch (45 degree angle). Duct connector must point up. DO NOT 

MOUNT THIS PRODUCT IN A WALL.

3.  To avoid motor bearing damage and noisy and/or unbalanced 

impellers, keep drywall spray, construction dust, etc. off power unit.

4.  Please read specification label on product for further information 

and requirements.

READ AND SAVE 

THESE INSTRUCTIONS

WARRANTY

Installer: Leave this manual with 

the homeowner.

OPERATION

CLEANING & MAINTENANCE

For quiet and efficient operation, long life, and attractive appear-

ance - lower or remove grille and vacuum interior of unit with the 

dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If the 

motor bearings are making excessive or unusual noises, replace 

the blower assembly (includes motor and impeller).

Register your 

product online at: 

www.broan.com/register

Use an on/off switch or speed control to operate this ventilator. See 
“Connect Wiring” for details. Use of speed controls other than the 
Broan Models 78V and 78W may cause a motor humming noise.

Limited Warranty

Warranty Period and Exclusions:

  Broan-NuTone LLC (the “Company”) warrants to the original 

consumer purchaser of its product (“you”) that the product (the “Product”) will be free from 

material defects in the Product or its workmanship for a period of three (3) years from the date of 

original purchase.

The limited warranty period for any replacement parts provided by the Company and for any Products 

repaired or replaced under this limited warranty shall be the remainder of the original warranty period.

This warranty does not cover speed controls, fluorescent lamp starters, tubes, halogen and in-

candescent bulbs, fuses, filters, ducts, roof caps, wall caps and other accessories for ducting that 

may be purchased separately and installed with the Product. This warranty also does not cover 

(a) normal maintenance and service, (b) normal wear and tear, (c) any Products or parts which 

have been subject to misuse, abuse, abnormal usage, negligence, accident, improper or insufficient 

maintenance, storage or repair (other than repair by the Company), (d) damage caused by faulty 

installation, or installation or use contrary to recommendations or instructions, (e) any Product 

that has been moved from its original point of installation, (f) damage caused by environmental or 

natural elements, (g) damage in transit, (h) natural wear of finish, (i) Products in commercial or 

nonresidential use, or (j) damage caused by fire, flood or other act of God. This warranty covers 

only Products sold to original consumers in the United States by the Company or U.S. distributors 

authorized by the Company.  

This warranty supersedes all prior warranties and is not transferable from the original consumer 

purchaser.  

No Other Warranties:

 This Limited Warranty contains the Company’s sole obligation and your sole 

remedy for defective products. The foregoing warranties are exclusive and in lieu of any other war-

ranties, express or implied. 

THE COMPANY DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS 

WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING 

WITHOUT LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR-

POSE.

 To the extent that applicable law prohibits the exclusion of implied warranties, the duration 

of any applicable implied warranty is limited to the period specified for the express warranty above.  

Some states do not allow limitations on how long an implied warranty lasts, so the above limita-

tion may not apply to you. Any oral or written description of the Product is for the sole purpose of 

identifying it and shall not be construed as an express warranty.

Whenever possible, each provision of this Limited Warranty shall be interpreted in such manner as 

to be effective and valid under applicable law, but if any provision is held to be prohibited or invalid, 

such provision shall be ineffective only to the extent of such prohibition or invalidity, without invali-

dating the remainder of such provision or the other remaining provisions of the Limited Warranty.

Remedy:

  During the applicable limited warranty period, the Company will, at its option, provide 

replacement parts for, or repair or replace, without charge, any Product or part thereof, to the extent 

the Company finds it to be covered by and in breach of this limited warranty under normal use and 

service. The Company will ship the repaired or replaced Product or replacement parts to you at no 

charge. You are responsible for all costs for removal, reinstallation and shipping, insurance or other 

freight charges incurred in the shipment of the Product or part to the Company. If you must send the 

Product or part to the Company, as instructed by the Company, you must properly pack the Product 

or part—the Company is not responsible for damage in transit. The Company reserves the right to 

utilize reconditioned, refurbished, repaired or remanufactured Products or parts in the warranty repair 

or replacement process. Such Products and parts will be comparable in function and performance 

to an original Product or part and warranted for the remainder of the original warranty period.  

Exclusion of Damages:  THE COMPANY’S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR 

REPAIR OR REPLACE, AT THE COMPANY’S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE 

REMEDY UNDER THIS LIMITED WARRANTY AND THE COMPANY’S SOLE AND EXCLUSIVE OBLI-

GATION. THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, INDIRECT, CONSEQUENTIAL 

OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE PRODUCT, ITS USE 

OR PERFORMANCE.

  

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the 

above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, 

and you may also have other rights, which vary from state to state.  

This warranty covers only replacement or repair of defective Products or parts thereof at the 

Company’s main facility and does not include the cost of field service travel and living expenses.

Any assistance the Company provides to or procures for you outside the terms, limitations or exclu-

sions of this limited warranty will not constitute a waiver of such terms, limitations or exclusions, 

nor will such assistance extend or revive the warranty.

The Company will not reimburse you for any expenses incurred by you in repairing or replacing 

any defective Product, except for those incurred with the Company’s prior written permission.

How to Obtain Warranty Service:

  To qualify for warranty service, you must (a) notify the Company 

at the address or telephone number stated below within seven (7) days of discovering the covered 

defect, (b) give the model number and part identification and (c) describe the nature of any defect 

in the Product or part. At the time of requesting warranty service, you must present evidence of 

the original purchase date. If you cannot provide a copy of the original written limited warranty, 

then the terms of the Company’s most current written limited warranty for your particular product 

will control. The most current limited written warranties for the Company’s products can be found 

at  

www.broan.com

 .

Broan-NuTone LLC    926 West State Street, Hartford, WI 53027 

www.broan.com

    800-558-1711

Содержание ULTRA SILENT QTXE150









Отзывы: