![background image](http://html1.mh-extra.com/html/brady/150744/150744_instruction-sheet_2800579001.webp)
7
0
2
?
1
?
1
1
2
3
4
7
0
2
?
1
7
?
Brady Inspection Timer Instruction Sheet
ENGLISH
Activate / Reset Timer
1. Press and hold
?
?
and
?
, lights turn
on in sequence, release when red light
flashes. Countdown begins at dark
green light.
2. New countdown has started.
A
Calendar button
B
Dark green LED light
C
Light green LED light
A
H
I
G
F
E
D
C
B
D
Yellow (amber) LED light
E
Inspection interval (7, 30, 90, 180, 365 days)
F
Red LED light
G
Battery button
H
Replace battery indicator
I
Lockout device hole
Inspection Status
During the inspection period, the LED lights periodically flash to indicate the time remaining before an inspection
is due.
• Dark green LED – beginning of inspection period, LED flashes every 2 minutes
• Light green LED – early in inspection period, LED flashes every 2 minutes
• Yellow (amber) LED – nearing end of inspection period, LED flashes every 10 seconds
• Red LED – inspection period has passed, LED flashes every 2 seconds
To manually check the time remaining before your next inspection:
1. Press and hold
?
?
for 2 seconds.
2. LED for remaining time flashes for 5 seconds.
When the Red LED flashes, carry out your inspection and reset the timer (see Activation / Reset Timer). The red
LED flashes for 7 days. After 7 days, the device enters sleep mode to conserve battery life.
Battery Status
When the battery power is critically low,
flashes red.
To manually check the battery status:
1. Press and hold
?
for 2 seconds.
2. LED light turns on to indicate the remaining battery life.
a.
Dark green
battery full
c.
Yellow (amber)
replace batteries soon
b.
Light green
battery good
d.
Red
replace batteries now
Replace Batteries
The device is powered by (3) AAA Batteries. To replace the batteries:
1. Turn front face counter-clockwise to remove it from
back plate.
2. Remove old batteries.
3. To maintain the countdown time, install new batteries
within 45 seconds of removing the old batteries.
4. Place the front face on the back plate and turn
clockwise to complete battery replacement.
5. Press
?
to re-enable power to the device. Check
calendar to ensure power has been restored.
6. If no light flashes, press and hold
?
?
until all LEDs flash.
7. Timer resumes the current time countdown.
Attaching Timer to Item
Attach Timer by using:
• Cable tie (up to .30” width)
• #6 screw (3.5 mm)
• Adhesive backing
• Hook and loop
• Magnet
Lockout devices:
• Padlock
• Security seal
7
0
2
?
1
?
7
0
2
?
1
7
?
day left
1
7
0
2
?
1
?
www.BradyCorp.com/global
© 2019 Brady Worldwide Inc. ALL RIGHTS RESERVED
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
CAN ICES-3(A) / NMB-3(A). Patent Pending. Made in China.
7
0
2
?
1
?
3
Before Use
When first removing out of the box,
press and hold
?
?
until all LEDs
flash. Now start / reset the timer.