ISW-EN1262 Installation Guide
PIR Motion Sensor-Transmitter
Overview
The ISW-EN1262 is a low-current motion detector that is highly
sensitive to moving heat (infrared radiation) sources.
Use the ISW-EN1262 in residential and low-traffic commercial
applications.
1.0
Open the Detector Housing
1.
Insert a small flat-blade screwdriver at a 45
°
angle into the tab
on the bottom of the unit.
2.
Press downward on the handle of the screwdriver until the
latch holding the cover to the housing base releases.
Refer to
Figure 1
.
Figure 1: Open the Housing
Figure 2: Detector Components
1
2
3
4
6
7
5
NZ
1 -
Wall Tamper pins
2 -
Battery
3 -
Circuit Board Attachment latch
4 -
Housing Tamper switch
5 -
Look-down lens
6 -
Reset button
7 -
Frequency Band pins
2.0
Mount the Housing Back Plate
1.
Pull the circuit board attachment latch and lift the circuit board
out of the housing.
Refer to
Figure 2
.
2.
Use a 3/16 in. (4.8mm) bit to drill out the tamper rivet hole
index. Refer to
Figure 3
on page 1.
3.
Install the tamper wall anchor.
Figure 3: Mounting Holes
1
2
3
2
2
3
2
1 -
Taper rivet hole
2 -
Corner- mount hole
3 -
Wall mount hole
4.
Mount the housing using either the three wall-mount holes or
the four corner-mount holes.
-
Use a 4 mm (5/32 in.) bit to drill the appropriate housing
holes.
-
Use the included screws to mount the housing.
If using the wall tamper:
-
Ensure that the wall tamper rivet depresses the
wall tamper switch. Refer to
Figure 4.
-
Remove the jumper plug from the wall tamper
selection pins. Refer to
Figure 2
, page 1.
Figure 4: Wall Tamper Switch
1
2
1 -
Wall tamper rivet
2 -
Wall tamper switch arm
