1
4
This equipment is de-
signed to be operated un-
der the following environ-
mental conditions:
Temperature between 0°
C –55°C. Relative Humidity
of 20% - 70% non-
condensing.
Operation of the unit
outside of the above range
may affect structual and
mechanical integrity and
cause permanent damage.
Caution is necessasry to
minimize ESD (Electro-
stactic Discharge) which
can damage electronic
components. Use in a
controlled environment
where ESD materials and
practices are employed is
highly recommended.
Blackhawk™
USB560
JTAG
Emulator
QUICK
START
GUIDE
Installation Requirements
•
PC or Notebook computer with at least one free USB v1.1 or v2.0
port.
•
Windows® 98, ME, 2000 or XP Operating System
•
Texas Instruments Code Composer Studio Version 2.1
†
or later.
•
CD-ROM Drive.
Inventory of Items Included
1. Blackhawk USB560 JTAG
Emulator POD.
2. USB 2.0 Compliant Cable.
3. 5 Volt DC power supply.
4. AC power cord.
5. JTAG target cable.
6. Installation CD .
7. Product Registration Card.
8. Quick Start Guide.
Other Items Required
1. Target Board System—a self-
powered board with a TI DSP
and compatible JTAG header
connection conforming to
IEEE 1149.1 Standard.
2. Copy of Code Composer
Studio Version 2.1
†
or later.
4 Code
Composer Studio Setup
CCS V2.1 and later Setup
1. Run CCS Setup.
2. Select the TI XDS560 driver from the available board types
that corresponds to the DSP on your target hardware. (i.
e. tixds560C55x.dvr—C55xx XDS560 Emulator).
3. Select “add to system” for this board type, which should dis-
play the board properties dialog box.
4. Click “next” on the “Board Name and Data File” tab.
5. On the “Board Properties” tab, change the Emulator Name
field from XDS560 0 to BH560USB 0, and click “next”.
6. On the “Processor Configuration” tab add the device(s) for
your target board and click “next”.
7. On the “Startup Gel File(s)” tab select the appropriate GEL
file for each CPU if applicable and click “finish”.
8. This will place a board into the system configuration win-
dow in CCS setup.
9. Save changes and exit.
10. If the USB560 is connected to the hardware and powered,
CCS can be started.
Important Environ-
mental Considerations
Blackhawk
123 Gaither Drive
Mt. Laurel, NJ 08054-1701
www.blackhawk-dsp.com
+1-877-983-4514
Blackhawk is a registered trademark of EWA Technologies, Inc.
USB560-QS-03
†
For CCStudio v2.1 (only), download the XDS560 emulation driver subsystem from the TI
web site:
https://www-a.ti.com/downloads/sds_support/XDS560Update.html
. These files are
included with CCS v2.2 and later.
NOTE:
The USB560 interface to Code Composer Studio is specifi-
cally designed to meet the TI XDS560 driver (DVR) specifi-
cation. Therefore, when configuring CCS, you simply spec-
ify the same parameters as the TI XDS560 for your target
hardware, except for the Emulator Name field. This should
be changed to indicate “BH560USB 0”, not “XDS560 0”.
