BEL STEWART 298007X-01 CRIMP TOOL Complete with dies
From MN290008 Rev A3
55-3219 BEL STEWART 2980075-01 CRIMP TOOL Complete with dies for RJ45 shielded Cat6 plugs
55-3220 BEL STEWART 2980078-01 CRIMP TOOL Complete with dies for RJ45 shielded Cat6A plugs
Crimping tools for SS-39200-0xx shielded plugs, specifically:
For Cat6 cables:
0.94 – 1.07mm conductor insulation dia.
5.9 – 6.3mm outside dia.
46-657 BEL STEWART SS-39200-011 RJ45 Cat6 FTP, shielded (pack of 5)
46-6417 BEL STEWART SS-39200-011 RJ45 Cat6 FTP, shielded (pack of 100)
For Cat6A cables:
0.42 – 1.22mm conductor insulation dia.
6.86 – 7.49mm outside dia.
46-658 BEL STEWART SS-39200-030 RJ45 Cat6A FTP, shielded (pack of 5)
46-6418 BEL STEWART SS-39200-030 RJ45 Cat6A FTP, shielded (pack of 100)
IMPORTANT:
Never use cable having outer diameter larger than specified
Only plugs of appropriate type should be used with the tool.
1. Prepare the Tool
In order to place the dies-set in the toolframe, close the handles just as
enough as to make the slot on pusher fully visible (do not close it fully)
(Fig.1).
Insert the dies-set 298007x-01 in the toolframe and make sure that pulling
bolt “A” matches the slot in the pusher.
After the dies-set is properly positioned in the toolframe, fix it by means of
socket head cap screw “B“.
Figure 1
