Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.mybayco.com
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.mybayco.com
INS-1002-14
500 Watt Halogen Work Light
Important Safety Instructions
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
•
Do not use with extension cord near water or where water may
accumulate.
•
Keep plugs and receptacles dry.
•
For use only on GFCI protected circuits.
•
Risk of burns, do not operate without guard. (See assembly instructions.)
•
Lighted lamp is hot.
Keep away from combustibles. Unplug to change
bulb. Do not touch bulb
WARNING RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE
TO EXCESSIVE UV RADIATION OR INJURY TO PERSONS
•
Unit operates on 120V AC 60 Hz only
•
Unplug and allow cooling before replacing bulb.
•
Bulb gets HOT quickly
•
Do not touch hot lens guard or enclosure.
•
Do not remain in light if skin feels warm.
•
Do not look directly at lighted lamp.
•
Keep lamp away from materials that may bum.
•
Use only with a 500 Watt or smaller type T bulb.
•
Do not touch the bulb at any time; use a soft cloth or gloves. Oil from skin
may damage bulb.
•
Do not operate the lamp with missing or damaged guard, lamp
containment barrier or UV light filter.
SAVE THESE INSTRUCTIONS
WARNING:
When using outdoor use work lights, basic safety precautions
should always be followed to reduce the risk of fire, electrical shock, and
personal injury, including the following:
•
Use only three-wire outdoor extension cords that have three-prong
grounding plug and receptacles that accept the appliance's plug.
•
Ground Fault Circuit Interrupter (GFCl) protection should be provided on
the circuit(s) or outlet(s) to be used for the wet location work light.
Receptacles are available having built-in GFCI protection and are able to
be used for this measure of safety.
•
Use only an extension cord for outdoor use, such as an extension cord of
cord type SW, SW-A, SOW, SOW -A. STW, STW-A, STOW. STOW-A.
SlW, SlW-A. SlOW. SlOW-A. SJTW. SJTW-A. or SJTOW, SJTOW-A.
BULB INSTALLATION AND REPLACEMENT
DO NOT TOUCH BULB WITH BARE HANDS
1.
Turn the light off and unplug from the power source.
2.
Allow the fixture to fully cool before proceeding.
3.
Always wear gloves or use a clean cloth to handle bulb. The natural oil
from skin will leave a residue that will cause the light to burn out
immediately.
4.
To remove the lens cover, remove the retaining screw on the front of the
lens cover. The lens cover will then swing open exposing the bulb.
5.
To remove the bulb, grip one end of the bulb and gently push towards the
other end and pull outward to release the bulb.
6.
Using a clean cloth or wearing gloves to hold the bulb, gently insert one
end of the bulb into the receptacle and press firmly into place. Place the
other end of the bulb into the opposite receptacle and gently press into
place. Make sure bulb is seated properly.
7.
Close the lens cover and replace the retaining screw.
8.
Do not test light without lens cover properly attached.
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and
materials to the original purchaser for 1 year from the date of purchase, and includes the
LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers. Bulbs
(other than LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or fitness
for a particular purpose.
For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-
support/warranties. Retain your receipt for proof of purchase.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco-product-
support/warranties. Retain your receipt for proof of purchase.
500W Lampe de Travail Halogenes
Lire toutes les intructions attentivement
AVERTISSEMENT: LISEZ ATTENTIVEMENT TOUTES LES INSTRUCTIONS
CONSERVEZ CES INSTRUCTIONS
ATTENTION: RISQUE DE CHOC ELECTRIQUE
•
Ne pas utiliser avec une rallonge pres d'un point d'eau ou d'accumulation
d 'cau
•
Garder les fiches et les prises de courant seches
•
Utiliser uniquement sur Ies circuits proteges GFCI
•
Risques de brulures. Ne pas utiliser sans I 'entourage (voir les
instructions d'assemhlage)
•
Risques d 'incendie / de blessurre.
Tenir la lampe eloignee des
proudits combustibles Debrancher pour changer l' ampoule. Ne pas
toucher I' ampoule.
AVERTISSEMENT RISQUE D'INCENDIE, DE CHOC ÉLECTRIQUE,
EXPOSITION AU RAYONNEMENT UV EXCESSIVE OU DE BLESSURES
•
Fonctionne sur du l20V AC / 60 HZ uniquement
•
Debrancher et laisser refroidir avant de remplacer I' ampoule.
•
L'ampoule devient CHAUDE rapidement
