![background image](http://html.mh-extra.com/html/bandb-electronics/eir618-series/eir618-series_quick-start-manual_459785001.webp)
EIR618 Series-5107qsg
International Headquarters:
707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
815-433-5100 Fax 433-5104
www.bb-elec.com
European Headquarters:
Westlink Commercial Park Oranmore Co. Galway Ireland
+
353 91 792444 Fax +353 91 792445
www.bb-europe
.com [email protected] [email protected]
Quick Start Guide
Elinx Managed Ethernet Switch
EIR618 Series
Items Included
1
2
3
LED Chart
Hardware Installation
Log into the Switch
5
4
o
Ethernet Switch
o
Console Cable (RS-232 RJ-45 to DB-9)
o
CD with Support Manual
o
This Quick Start Guide
o
Panel Mount Bracket
o
IP Address: 192.168.16.1
o
Subnet Mask: 255.255.255.0
o
Gateway: 192.168.16.254
o
User Name: root, Password: root
LED Status
Meaning
Green
The Switch is powered on
PWR
Off
The Switch is powered off
Green
Power Source 1 is available
PWR1
Off
Power Source 1 is unavailable
Green
Power Source 2 is available
PWR2
Off
Power source 2 is unavailable
Red
Power or Port failure
Fault
Off Normal
Operation
Green
The Switch is the master of a redundant
ring (X-Ring)
R.M
Off
The Switch is not the master of a
redundant ring.
Green
SFP Port is linked
Blinking
Data is being transmitted or received
LINK/ACT
Port 17/18
*
SFP
Off
Not connected to the network
T Green Port
is
linked
T Blinking
Data is being transmitted or received
T Off
Not connected to the network
B Green
Operating at 1000M
Port
17/18*
RJ-45
B Off
Disconnected or below 1000M
T Green
Connected to the network
T Blinking
Data is being transmitted or received
T Off
Not connected to the network
B Yellow
Operating in full-duplex
B Blinking Data
collision
P1-16
*
B Off
Half-duplex or not connected
*Note
Ports 1 through 16 are 10/100 RJ-45, Ports 16 & 17 are
100/1000 RJ-45 or SFP.
o
Record the switch’s MAC Address in the space
provided. The MAC Address is printed on the product
label. NOTE: Provide the MAC Address to your
Network Administrator. The Network Administrator
should provide an IP Address, Subnet Mask, and
Gateway.
o
Select a mounting location and install with the attached
DIN rail clip or included panel mount kit.
o
Connect power to the switch
o
12 to 48 VDC
o
Redundant inputs are available with fault
contacts.
NOTE: The installation of an SFP Module disables
the associated RJ-45 Port.
o
These instructions are for Web based management.
Refer to the User’s Manual for instructions concerning
console management.
o
Connect a switch port to a stand alone PC. Change the
PC’s network IP Address to allow it to connect to the
switch (ex: 192.168.16.2). Use the default subnet mask
and gateway.
o
Launch the PC’s web browser and navigate to the
switch by typing the switch’s IP Address in the browser
address window.
o
Navigate the web page by expanding the folders on the
left side of the web page.
Default Settings