Recordall® Disc Series Meters
Cold Water Disc Meters, 5/8 in. to 2 in.
Installation Manual
RDM-UM-00059-EN-05 (January 2018)
SAFETY INFORMATION
The installation of the Recordall® Disc Series Meters must
comply with all applicable federal, state, and local rules,
regulations, and codes.
Failure to read and follow these instructions can lead to
misapplication or misuse of the Recordall® Disc Series Meters,
resulting in personal injury and damage to equipment.
PRODUCT UNPACKING AND
INSPECTION
Upon opening the shipping container, visually inspect the
product and applicable accessories for any physical damage
such as scratches, loose or broken parts, or any other sign of
damage that may have occurred during shipment.
OTEE:
N
If damage is found, request an inspection by
the carrier’s agent within 48 hours of delivery
and file a claim with the carrier. A claim for
equipment damage in transit is the sole
responsibility of the purchaser.
METER PRE-INSTALLATION
Take into account the following considerations before you
begin an installation:
• Inspect the piping around the meter for suitable
conditions. The service line, valves, connections and
meter must be watertight. Repair the piping system if
pipes are corroded or damaged.
• Install the meter in the pipeline in a horizontal position
so that the flow arrow on the meter housing points in
the same direction as water flow. Registration should be
upright and protected from damage, freezing,
and tampering.
• Position the meter so it is accessible for installation,
removal and reading.
• Verify that a suitable electrical grounding wire is properly
attached to the upstream and downstream pipe
connections of the meter. The grounding wire provides an
alternative path for any electrical current that may exist
across the opening in the line.
• Close the curb (shutoff) valve to relieve water pressure in
the line before starting the cutting operation. Provide a
high-quality upstream shut-off valve with a low
pressure drop.
• When cutting into a new section of service pipe,
flush the pipe to clear chips, pipe dope or other
plumbing residue.
• The installed meter must not be an obstacle or a hazard
to the customer or interfere with public safety.
• DO NOT ATTEMPT TO USE ANY METER AS A LEVER OR
CROWBAR TO STRAIGHTEN A MISALIGNED METER
POSITION. THIS COULD DAMAGE THE METER.
• DO NOT ATTEMPT TO INSTALL A METER INTO AN
OPENING THAT IS TOO LONG BY FORCING THE PIPING
INTO PLACE WITH THE METER'S COUPLING NUTS. THIS
WILL CAUSE SERIOUS DAMAGE TO THE THREADED ENDS
OF THE METER AND HOUSING.
• TO AVOID POTENTIAL PROBLEMS, CORRECT ANY
IRREGULARITIES IN PIPE SPACING AND MISALIGNMENT
BEFORE PLACING THE METER INTO ITS POSITION.
