![background image](http://html1.mh-extra.com/html/austral-lock/elegance-push2go/elegance-push2go_illustrated-fitting-instructions_3019512001.webp)
oem1doc03_R2
●
Lockbody screws.
ELEGANCE
P U S H 2 G O
for hinged security doors
ILLUSTRATED FITTING INSTRUCTIONS
●
Lockbody screws.
●
Lockbody screws.
1.
LOCKBODY INSTALLATION
3.
EXTERIOR FURNITURE
4.
INTERIOR FURNITURE
5.
INSTALL THE FURNITURE
●
The
Sticker
on the rear of
the
Lockbody
is to assist
in easy installation. - Do
not remove.
●
If the
Sticker
has been
broken or removed, en-
sure that the
Rear Slide
is pushed completely
down before assembling
the
Lockbody
into the
door cutout.
●
Insert the
Lockbody
into
the door cutout
●
Secure the
Lockbody
with the two #8x13mm
Lockbody screws.
Sticker
Rear Slide
2.
CYLINDER INSTALLATION
●
Depress the
Auxiliary Bolt
to ensure the
Main Bolt
is
fully extended.
●
Assemble the
Cylinder
through the lock so the
Cyl-
inder
protrudes equally from
both sides.
NOTE : the
Cylinder Cam
must rotate as shown below.
(cam turns towards front of
door)
●
Insert the
Key
and turn to
locked position.
●
Insert #10 x 38mm
Cylinder
Screw
& tighten.
NOTE : test,
Main Bolt
should not depress.
●
Turn
Key
to unlocked posi-
tion and remove
Key
.
Cylinder
Screw
Main
Bolt
Auxiliary
Bolt
Cylinder
Cam operation
Handle
Rod
Cylinder
Cam
IMPORTANT : If installing PUSH2GO with a multipoint acces-
sory kit, be sure to follow the cylinder installation procedure
within the multipoint kit instructions.
●
Select the
Exterior Handle
assembly.
●
If the
Handle
does not point
towards the door hinges,
remove it from the
Handle
Plate
and exchange with
the other handle.
●
Ensure the
Locking Hub
is
rotated so the pip is closest
to the door edge.
rotate
Hub
so that
the pip is closest
to door edge
●
Select the
Interior Handle
assembly with
Snib Lever
hole.
●
Hold the
Snib Lever
hor-
izontally and insert it into
the snib lever hole, turn it
until vertical to secure it.
●
While holding the Snib
Lever vertical, place the
Lever Assembly
against
the door.
●
Insert the
Handle Rod
through the
Lock Body
.
●
Locate the
Exterior
Handle
assembly over
the
Lock Body
.
●
Engage
Snib Lever
into
Locking Hub
.
●
Fit the two
#8x32mm
Furniture screws
.
PLEASE TURN OVER
Austral
宏
ock