Dis-Assembly Instructions
1.
Hold the Air Jack in a vice using the pair of threaded Body Clamps (Tool 1). Do not over tighten.
(See Fig 1.)
2.
Using 2 standard ‘C’ spanners (Not supplied), lock together a pair of the Air Jacks Mounting Rings supplied with the
Airjack.
(See Fig 1.)
3.
Remove from the vice and fit the Cap Clamp (Tool 2) to the knurled Airjack Cap. Locate the Air Jack and Cap Clamp
vertically, clamping the Cap Clamp in the vice.
(See Fig 2.)
4.
Using a ‘C’ spanner, rotate the lower Mounting Ring anti-clockwise to unscrew the Body from the Cap. Note:- Approxi-
mately every ½ turn of the Body, use Pin Tool (Tool 3), located in the Airjack Foot to rotate the Foot clockwise ½ turn. This
is to prevent the internal Tension Spring being wound up and damaged.
Continue for approximately 6 full turns until the Cap thread is fully out of the Body. The internal Tension Spring will keep the 2
parts pulled together.
(See Fig 2.)
Fig 1.
Fig 2.
AP Racing, Wheler Road, Coventry, CV3 4LB, UK
Tel: +44 (0)24 7663 9595 Fax: +44 (0)24 7663 9559 E-Mail:[email protected] Web: www.apracing.com
Publication Ref: P14.083 - Issue 2
Continued Overleaf........
CP2985 Air Jack
Servicing Instructions
(Kit Part Number CP4985-10)
