background image

Quick-Start-Guide for AOR ARD9000

carefully reading may make your start into Digital-Voice much easier

CONNECTION:

In general it is recommended to connect the 

ARD9000

 to a separate power supply, other than

the one used for the radio. However, attempts have shown that it does not necessarily lead to
complications if the DC power is taken from the same power supply. We managed to use the

ARD9000

 and radio connected to the same supply without recognizeable problems - however,

it may vary from setup to setup and you have to check locally – if not working, better step
back to separate power-supplies for radio and 

ARD9000

.  Switched-power-supplies seem to

be mostly causing trouble and are not recommended to be used

Wiring the  

ARD9000

  <> radio cable should be taken from the  

AOR

  manual.   In case your

radio does not offer a PTT-L pin, you have to shortcut this one with GND. Shielded cable as
well as a good frame ground between both units are necessary

Usage of an external speaker, connected to the speaker-out connector, makes listening more
pleasantly

TRX SETTINGS:

TX output should not exceed 50 % of the maximum setting to avoid damage of your final
transistors.  The  Multi-Carrier-Digital-Signal   (36  carriers) puts  your  final  transistors   under
stress in maximum power output

AGC setting should be FAST. Minimal required SSB bandwidth is 2.4 kHz - not to be limited
by internal filter settings or build-in DSP units

ALC readout should not exceed 60 % of max. level. Adjusting the max. ALC level should be
done by MIC-gain (TX side)

We strongly recommend to use the provided speaker-microphone during your first test-

contacts. None of the factory set potentiometer settings, located on the underside of the

device, should be changed. Any adaptation of the work settings assumes experiences in

Digital-Voice

 as well as a co-hearing receiver or experienced test partner.

Attention

 especially the digital output setting would have to be carried out very precise. 

Your 

ARD9000

 has been properly adjusted at the factory

 !! DO

 

NOT

 

TRY

 

TO

 "

IMPROVE

THINGS

 

WHICH ARE NOT NEEDED

 

!!

Reviews: