-1-
-2-
L100K/L100
Installation Instructions
Before Connecting, operating or adjusting this product, please read the instructions carefully.
Keep this manual in case you need it at a later date.
is registered trademark of Anviz Global Inc. in the United States and other countries. It cannot be used without the
permission of Anviz.
Please scan this bar
code to win Anviz vCard
www.anviz.com
Intelligent.Security
BIOMETRIC - RFID - SURVEILLANCE
Product And Accessories
Outside panel
Inside panel and battry cover
Latch Bolt
Step 3
Step 4
Step 5
Step 6
Installation
* See Note 1
Step 1
Step 2
* See Note 2
Install the lock spindle through the
latch bolt and make sure the lock
spindle plugs into the outside panel.
2 Rubber mats and 1 mounting plate
Lock Spindle, Screwdriver and fixing Screws
(4 long screws for outside panel mounting,
2 short screws for inside panel mounting,
2 short screws for bolt fixing.)
Insert latch bolt into the door as shown
in diagram. Fasten the screws
.
Install
Mounting Plate
with Rubber Mat and route
wire through left hole. Install four screws on the
Mounting Plate
to fix the position.
Recommend: DO NOT OVER TIGHTEN the two
screws above.
Remove the above 2 screws installed on
mounting plate. Connect wire from the
Outside panel to Inside panel. Install
lock
spindle into inside panel.
L100K
L100
RFID cards (L100) and Emergency keys
RF Key
RF
L100K/L100
Installation Guide
(V3.1)
Install outside panel with rubber mat on
door, and route the wire through the hole
over the latch bolt.
Note 1: Make sure the hole dimension is fit for bolt installation (Refer to chapter “New Door Preparation”).
Note 2: Make sure the bottom screw rod get through the holes in latch bolt.
Fasten four screws to fix the inside panel.
Turn the knob to make sure that you can
push the dead bolt.
Install alkaline batteries and battery cover.
Initialization button
Home & Business Smart Lock
