![background image](http://html.mh-extra.com/html/american-lighting/ls-series/ls-series_installation-instructions_2924657001.webp)
Page 1 of 3
REV1731
Installation instructions for LS-M, LS-MS, LS-I, and LS-C light string product for permanent installation
Commercial Grade Light String
WARNING : These products may represent a possible shock or fire hazard if improperly installed or attached
in any way. Products should be installed in accordance with these instructions; and current electrical codes
and/or the current National Electric Code (NEC).
CAUTION – To reduce the risk of fi re, electric shock or inju ry to persons:
1. Commercial Grade Light String is intended for installation by trained, qualified electrical contractors.
2. Light string can be supported by steel guide cables, with zip ties and eyebolts. Proper diameter cabling
must be used for the maximum span distance between supports according to local building codes. See
chart on reverse side for maximum span distances between supports.
3. Suspend strings properly by attaching suspension cable (not provided) to solid support structures, such
as joists, beams or wall studs.
4. Light sockets must be suspended so that bulbs are facing down ONLY.
5. Keep combustible material clear of bulbs. Do NOT allow lamps or sockets to come into contact with walls,
ceilings, fabrics associated with shades, blinds or other materials. Lamps should hang freely in a
downward direction with a minimum of 3” space from the nearest object.
6. Do not cluster the bulbs.
7. Not intended for installation in ceilings, soffits, cabinets or other enclosed spaces.
8. Not intended for lighting aquariums.
9. Do NOT secure light string to buildings or other structural supports using nails, staples or other sharp,
conducting materials.
10. Avoid damage to the insulation during installation. Do NOT pierce or other wise compromise wire’s or
socket’s outer covering, jacket or sheathing.
11. Periodically inspect wire and sockets for degradation due to weather, UV light or other damage.
Promptly replace worn out light string.
12. DO NOT MOUNT THE LIGHT STRINGS WITH SOCKETS FACING UP WARD!
13. DO NOT OVER LOAD ANY SOCKE T’S M AXIMUM WATTAGE RATING!
14. DO NOT OVER LOAD MAXIMUM WATTAGE CAPACITY IN ANY RUN!
WARNING – RISK OF ELECTRIC SHOCK!!
Disconnect power at source prior to wiring, re-lamping or servicing in any way.
LIGHT STRING SETS WITH POLARIZED PLUG
1. Do not connect the light string to any other string.
2. The plug-in light string sets are supplied with an attached polarized plug that will only fit into a polarized out-
let. If it does not fit, reverse the plug. If it still does not fit, contact a qualified electrician. Do not alter the plug.
3. DO NOT EXCEED THE M AXIMUM WATTAGE FOR LIGHT STRING SE TS WITH ATTACHED P LUG:
600 WATTS MAXIMUM FOR 48 FOOT PLUG-IN LIGHT STRING SETS!
1250 WATTS MAXIMUM FOR 100 FOOT PLUG-IN LIGHT STRING SETS!