Installation Instructions
For Part Number:
450-330
2015-17 Ford Mustang 2.3l EcoBoost 4 Cyl.
Component
Identi ication
1
Airaid Premium Filter
1
2
Airaid Intake Tube
1
3
Top Panel
1
4
Bottom Panel
1
5
Filter Adapter
1
6
Weatherstrip 23"
1
7
Reducing Coupler
1
8
Hump Hose
1
9
#40 Hose Clamp
1
10
#56 Hose Clamp
1
11
#68 Hose Clamp
2
12
Aluminum Fitting
1
13
#8 Flat Washer
1
14
8‐32 Button Head
1
15
13/16" ID Grommet
1
16
O‐Ring
1
17
¼"‐20 Button Head
4
18
1/4" Flat Washer
3
19
1/4‐20 X 1/2"L Button Head
3
20
Grommet
1
21
¼" Lock Washer
4
22
Airaid Decal
1
1.
Remove the battery box cover in the cowl and discon-
nect the negative battery terminal.
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance
please call 1-800-858-3333 to speak with a representative in our Customer Service Center before
returning the product.
2.
Loosen the clamp on the intake tube and slide it off
of the airbox. Gently pry the harness anchor out of the
airbox and disconnect the air temp sensor.
Air temp sensor
Anchor
3.
Remove the 6mm airbox mounting bolt in the inner
fender and lift the entire airbox assembly out of the vehi-
cle. Set the bolt aside for now. It is to be reused.
4.
Be sure to retain speed clip in the inner fender .
5.
Loosen the clamp on the turbo inlet coupler.
6.
Disconnect the PCV and turbo bypass lines from the
intake tube and remove the tube from the vehicle.
9.
Tilt the air temp sensor rearward so the locking tab
clears the ramp and rotate it counterclockwise 1/4 turn to
release it.
7.
Insert the Grommet and Aluminum Fitting into the
Airaid Intake tube as shown.
8.
Slide the Reducer and Clamps onto the turbo side of
the Intake Tube as shown. Leave the clamps loose for
now.
Fitting
Grommet
#40
#56
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION CON-
TROLLED MOTOR VEHICLE IN CALIFORNIA OR STATES
ADOPTING CALIFORNIA EMISSION PROCEDURES.
See AIRAID.COM for CARB status on each part for a specific vehicle.
