A
A
B
C
D
F
F
H
G
D
FACTORY
PART
FACTORY
PART
E
I
Installation Instructions
400-758
860-397 Airaid Oiled Media Filter
401-758
861-397 SynthaMax Dry Media Filter - Red
Component Identification
2018 FORD F150 / F150 Raptor / Expedition
2018 LINCOLN Navigator
V6-3.5L
For Part Numbers:
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
a representative in our Customer Service Center before returning the product.
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner’s manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
TO START:
Description
Qty. Part #
A
HOSE CLAMP; #48
2
08601
B
HOSE; 3"ID X 2"L REINFORCED
1
08711
C
TUBE; INTAKE, 40%-758
1
KIT758A
D
HOSE CLAMP; #60
2
08624
E
HOSE; 3.75"ID X 2.25"L
1
08760
F
HOSE CLAMP; #64 STAINLESS
2
08645
G
HOSE; 4"ID X 2"L REINFORCED
1
08761
H
AIR FILTER
1
860/861-397
I
GROMMET; 1"OD,1/2"ID,1/2"THK
1
08064
2. Disconnect the inlet air temperature sensor electrical
connection.
3. Loosen the hose clamp that secures the factory intake
tube to the upper air filter housing.
4. Release the locking clamps, lift up the upper air
filter housing and then remove it from the vehicle, then
remove the factory air filter.
5. Loosen the two remaining hose clamps that secure
the factory intake tube to the turbo inlet tubes and then
remove the intake tube from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
7. Install the provided coupler hose (08761) onto
the driver’s side turbo inlet tube and secure with the
provided hose clamp.
