- INSTRUCTIONS -
The MYW-MD/B adaptor converts the video from a 2-wire signal to a standard coaxial video signal
(Demodulator mode). It can also be used to convert a standard CCTV camera's signal to a 2-wire signal
(Modulator mode).
The MYW-MD/B is compatible with Aiphone's MK and MY series video monitors.
MYW-MD/B
Video Modulator/Demodulator for MK and MY Series Video Systems
MYW-MD/B TERMINAL DEFINITIONS:
MODULATOR:
MA1
2-Wire output to
MA2
MY monitor/adaptor
MV+
Coax input: center cond.
MV-
Coax input: Braided shield
+
Positive 18V DC
-
Negative
Input signal requirements:
75 ohm, 1V peak-to-peak.
Coax: Solid copper core with copper braid.
DEMODULATOR:
DA1
2-Wire input from
DA2
MK or MY monitor/adaptor
DV+
Coax output: center cond.
DV-
Coax output: Braided shield
+
Positive 18V DC
-
Negative
Output signal:
75 ohm, 1V peak-to-peak.
Coax: Solid copper core with copper braid.
Special
Order
Products
MODULATOR
MYW-MD/B to integrate a Standard CCTV camera with an Aiphone Monitor
*MYW-MD/B Can also be used with:
MK-1MD/A
MY-1CD
MY-CU
MYW-P1L
MYW-P3L
Center cond. to MV+
Braid to MV-
CCTV Camera
75 Ohm, 1V Peak-to-peak
(Independently powered)
1A1
1A2
2A1
2A2
B1
B2
+
-
MY-2CD*
MK-DBC
A1
A2
MA1
MA2
MV+
MV-
+
-
MYW-MD/B
PS-18C
+
-
Polarized
JUMPER CLIP:
Set in Modulator (top) position from factory. Ensure
that jumper clip is between the top two pins.
Pg. 1
DEVIATION CONTROL:
To increase contrast, turn clockwise
with a small screwdriver. Only applicable when
MYW-MD/B is used in Modulator mode. (See pg 4)
JUMPER CLIP AND DEVIATION CONTROL:
Located under rubber cover in upper right corner of the faceplate of the MYW-MD/B.
