![background image](http://html.mh-extra.com/html/abb/dodge-torque-arm-ii/dodge-torque-arm-ii_installation-and-instruction-manual_4025001.webp)
1
WARNING: Because of the possible danger to person(s)
or property from accidents which may result from the
improper use of products, it is important that correct
procedures be followed. Products must be used in
accordance with the engineering information specified
in the catalog. Proper installation, maintenance and
operation procedures must be observed. The instructions
in the instruction manuals must be followed. Inspections
should be made as necessary to assure safe operation
under prevailing conditions. Proper guards and other
suitable safety devices or procedures as may be desirable
or as may be specified in safety codes should be provided,
and are neither provided by ABB nor are the responsibility
of ABB. This unit and its associated equipment must be
installed, adjusted and maintained by qualified personnel
who are familiar with the construction and operation of
all equipment in the system and the potential hazards
involved. When risk to persons or property may be
involved, a holding device must be an integral part of the
driven equipment beyond the speed reducer output shaft.
WARNING: To ensure that drive is not unexpectedly
started, turn off and lock out or tag power source before
proceeding.
Remove all external loads from drive before removing or
servicing drive or accessories. Failure to observe these
precautions could result in bodily injury.
WARNING: Ensure that all guards are properly installed
before proceeding. Exercise extreme care to avoid
contacting rotating parts. Failure to observe these
precautions could result in bodily injury.
WARNING: All products over 25 kg (55 lbs) are noted on the
shipping package. Proper lifting practices are required for
these products.
Installation and Instruction Manual for Dodge
®
Torque-Arm II
Speed Reducer Belt Guard Assemblies
These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of
printing. Please see
baldor.com
for updated instruction manuals.
Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on
March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of
Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have
been updated to reflect our new corporate identity.
TORQUE ARM II BELT GUARD INSTALLATION:
Two different belt guards are available for the Torque-Arm
II speed reducer. One belt guard assembly is designed for
mounting in position “B” and the other belt guard assembly is
designed for mounting in position “C” as shown in Figure 1. It is
important that the mounting position of the Torque-Arm II Motor
Mount be determined prior to purchase of the belt guard as
these two guards do not interchange and will be attached to the
motor mount uprights.
POSITION B
POSITION C
Figure 1 - Belt Guard Mounting Positions