background image

Insert the 3M™ PPS™ Series 2.0 Spray Cup 

System disposable liner into the 3M™ PPS™ 

Series 2.0 Spray Cup System mixing cup.

1

2

Pour material to be sprayed into the 3M™ 

PPS™ Series 2.0 Spray Cup System mixing 

cup. Stir as needed.

4

Turn until tight. Insert 3M™ PPS™ Series 

2.0 Spray Cup System sealing plug prior to 

shaking or sealing.

5

Attach spray gun to filled 3M™ PPS™ Series 

2.0 Spray Cup System cup.

3

Place the 3M™ PPS™ Series 2.0 Spray Cup 

System lid with built-in filter on top of the 

3M™ PPS™ mixing cup with liner and snap 

into place.

Adding the 3M

 PPS

 Series 2.0 Spray Cup 

System Components

2

Attach the nozzle to the spray gun with 

the locking collar fully connected. 

Note: 

It is easier to install the nozzle while pulling 

the trigger backward toward the spray gun 

handle. 

To remove the nozzle from the spray 

gun, reverse the process.

4

Once the spray gun is properly assembled 

you may attach the air line.

3

Attach 3M™ PPS™ Series 2.0 spray cup 

to nozzle.

2.0 1.8 1.6 1.4 1.3 1.2

Direct Gloss
Single Stage Top Coat

Wet on Wet Primer

High Viscosity Coatings
Sprayable Fillers

Primer Surfacer

Solvent Base Color

Primer Sealer

High Build Primer

Clearcoat
Waterborne Base Coat

WARNING!

 Do not immerse spray gun or nozzles in cleaning solvents or gun washers. The maximum operational air pressure of this HVLP spray gun is 20 psi/ 1.38 bar.

Nozzle Recommendation

* Starting points only, refer 

to Paint Manufacture for 

recommendation on fluid 

tip size

Recommended Set Up Starting Points

Fan Control Knob: Open 2 rotations from closed position

Fluid Control Knob: Open 4 rotations from closed position

Air Flow control valve: 18-20 psi / 1.24 – 1.37 Bar

See manual for additional use and health and safety information.

  

bottom of the gun.

1

 

Attach the supplied air flow valve to the

Assembly

Maximum Operating Air Pressure: 20 psi | 1.38 bar

3M™ Performance Spray Gun HVLP – Gravity

Reviews: