Assembly
1
Attach the supplied air flow valve to the bottom of the gun.
2
Attach the nozzle to the spray gun with the locking collar fully connected.
Note: It
is easier to install the nozzle while pulling the trigger backward toward the spray
gun handle.
To remove the nozzle from the spray gun, reverse the process.
3
Attach 3M
™
PPS
™
Series 2.0 spray cup to nozzle. See back for directions.
4
Once the spray gun is properly assembled you may attach the air line.
For additional questions, contact your local 3M representative
or email: [email protected].
See manual for additional use and health and safety information.
Recommended set up starting points
Fan control knob: Open 1.5 turns for HVLP nozzles, 2.5 turns for Fine Finish
nozzles from closed position
Fluid control knob: Open 4 rotations from closed position
See recommended pressure setting on Atomising Head Air Cap.
Nozzle recommendation
* Starting points only, refer to Paint Manufacture for recommendation
on fluid tip size.
2.0
1.8
1.6
1.4
1.3
1.2
0.9
High viscosity coatings
•
•
Sprayable fillers
•
•
High build primer
•
•
•
Primer surfacer
•
•
•
Wet on wet primer
•
•
Primer sealer
•
•
Direct gloss
•
Single stage top coat
•
Solvent base colour
•
•
Clearcoat
•
•
•
Waterborne base coat
•
•
UV Primers
•
•
•
Midcoat / Effect Coats
•
•
•
Smart / Spot repair
•
WARNING!
Do not immerse spray gun or nozzles in cleaning solvents or gun washers.
*Operating Pressure Range (OPR) is the inlet pressure range for safe function of the spray gun.
3M
™
Performance Spray Gun – Gravity
Operating Pressure Range* is between 7 psi - 37 psi (0.5 bar - 2.6 bar)
