ZyAIR 100 Wireless PC Card Quick Start Guide
5
c)
Using
WEP
. The default is
Disable
. If you require high
security in transmission, please select the
Enable
item and
select
Key List
.
WEP
works in conjunction with all of your
clients. Therefore, you must enter the same key you have
entered for your other clients. For example, if you enter
MyCar
in key 1 for you PC Card, enter
MyCar
in key 1 for
all other clients. Please refer to the
Infrastructure
section
for
WEP
key input on the following page.
NOTE: When you use WEP to communicate with the other
wireless clients, all the wireless devices in this network
must have the same encryption key.
d)
Upon completing steps 1~3, click on
Modify
to save the
new values.
5. Using the ZyAIR 100 Utility to Set Up an Infrastructure
Network
Ê
On the main
ZyAIR 100
Utility
interface, click on
Diagnostic
Tools
and then click on
Access Points Browser
. This would
disable wireless connection temporarily and the subsequent
display would show status for all available access points.
Ë
Go back to t he main
ZyAIR 100
Utility
window and click on
Network Configuration
. Setup procedures are as follows:
a)
ESS ID
denotes the assigned name for the designated
wireless LAN. If the PC Card
ESSID
is different from the
Access Point, you will not have access to that wireless
segment. Note that by selecting
Use Non-Specified ESSID:
ANY
the
PC Card
could be connected to other wireless
LAN with a different
ESSID
. So,
ESSID
setup is highly
recommended. (e.g.,: Specify
ESSID
as: Wireless001)
