ZyXEL Communications ZyXEL Dimension ES-2724, User Manual, Page: 265 / 341

ES-2724 User’s Guide
Chapter 39 Introducing Commands 263
Use these commands to configure the IP routing domains.
39.11.6 config-vlan Commands
The following table lists the
vlan
commands in configuration mode.
Table 94 interface route-domain Commands
COMMAND DESCRIPTION
PRIVILEG
E
interface
route-domain
<ip-address>/
<mask-bits>
Enables a routing domain for
configuration.
13
exit
Exits from the interface routing-
domain command mode.
13
ip igmp <v1|v2>
Enables IGMP in this routing
domain.
13
igmp robustness-
variable <2-255>
Sets the igmp robustness variable
on the switch. This variable
specifies how susceptible the
subnet is to lost packets.
13
igmp query-interval
Sets the igmp query interval on
the switch. This variable specifies
the amount of time in seconds
between general query messages
sent by the router.
13
igmp query-max-
response-time <1-25>
Sets the maximum time that the
router waits for a response to an
general query message.
13
igmp last-member-
query-interval <1-
25>
Sets the amount of time in
seconds that the router waits for a
response to a group specific
query message.
13
rip direction
<Outgoing|Incoming|
Both|None>
Sets the RIP direction in this
routing domain.
13
no ip igmp
Disables IP IGMP in this routing
domain.
13
Table 95 Command Summary: config-vlan Commands
COMMAND DESCRIPTION PRIVILEGE
vlan <1-
4094>
Creates a new VLAN group. 13
exit
Leaves the VLAN configuration
mode.
13
fixed <port-
list>
Specifies the port(s) to be a
permanent member of this VLAN
group.
13