ZyXEL Communications ZyWALL 70, User Manual

Page: 393 / 705

ZyWALL 70 User’s Guide
Chapter 24 Logs Screens 393
Figure 195 Reports
Note: Enabling the ZyWALL’s reporting function decreases the overall throughput by
about 1 Mbps.
The following table describes the labels in this screen.
Note: All of the recorded reports data is erased when you turn off the ZyWALL.
Table 139 Reports
LABEL DESCRIPTION
Collect Statistics Select the check box and click Apply to have the ZyWALL record report data.
Send Raw
Traffic Statistics
to Syslog Server
for Analysis
Select the check box and click Apply to have the ZyWALL send unprocessed traffic
statistics to a syslog server for analysis.
You must have the syslog server already configured in the
Log Settings screen.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Interface Select on which interface ( LAN or DMZ ) the logs will be collected. The logs on the
DMZ or LAN IP alias 1 and 2 are also recorded.
Report Type Use the drop-down list box to select the type of reports to display.
Web Site Hits displays the web sites that have been visited the most often from the
LAN and how many times they have been visited.
Protocol/Port displays the protocols or service ports that have been used the most
and the amount of traffic for the most used protocols or service ports.
LAN IP Address displays the LAN IP addresses to and /or from which the most
traffic has been sent and how much traffic has been sent to and from those IP
addresses.
Refresh Click Refresh to update the report display. The report also refreshes automatically
when you close and reopen the screen.
Flush Click Flush to discard the old report data and update the report display.