ZyXEL Communications ZyAIR G-3000H, User Manual

Page: 80 / 299

G-3000H User’s Guide
80 Chapter 6 Wireless Security Configuration
6.12.5 Security: WPA, WPA-MIX, WPA2, WPA2-MIX
Select WPA , WPA-MIX , WPA2 or WPA2-MIX in the Security Mode field to display the
following screen.
Figure 35 Security: WPA, WPA-MIX, WPA2 or WPA2-MIX
The following table describes the labels not previously discussed
6.12.6 Security: WPA-PSK, WPA2-PSK, WPA2-PSK-MIX
Select WPA-PSK , WPA2-PSK or WPA2-PSK-MIX in the Security Mode field to display
the following screen.
Table 24 Security: WPA, WPA-MIX, WPA2 or WPA2-MIX
LABEL DESCRIPTIONS
Name Type a name to identify this security profile.
Security Mode Choose WPA , WPA-MIX , WPA2 or WPA2-MIX in this field.
ReAuthentication
Timer
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected.
Enter a time interval between 10 and 9999 seconds. The default time interval is
1800 seconds (30 minutes).
Note: If wireless station authentication is done using a RADIUS
server, the reauthentication timer on the RADIUS server has
priority.
Idle Timeout The ZyAIR automatically disconnects a wireless station from the wired network
after a period of inactivity. The wireless station needs to enter the username and
password again before access to the wired network is allowed.
The default time interval is
3600 seconds (or 1 hour).
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP (if using WPA-PSK key
management) or RADIUS server (if using WPA key management) sends a new
group key out to all clients. The re-keying process is the WPA equivalent of
automatically changing the WEP key for an AP and all stations in a WLAN on a
periodic basis. Setting of the Group Key Update Timer is also supported in WPA-
PSK mode. The ZyAIR default is 1800 seconds (30 minutes).
Apply Click Apply to save your changes back to the ZyAIR.
Reset Click Reset to begin configuring this screen afresh.