Chapter 79 Networked AV Mode
XGS2220 Series User’s Guide
598
Figure 444
SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
79.32 VLAN
This section shows you how to configure 802.1Q tagged and port-based VLANs.
79.32.1 What You Can Do
• Use the
VLAN Status
) to view and search all static VLAN groups.
• Use the
VLAN Detail
screen (
) to view detailed port settings and status of
the static VLAN group.
• Use the
Static VLAN
) to configure a static VLAN for the Switch.
• Use the
VLAN Port Setup
) to configure the static VLAN (IEEE 802.1Q)
settings on a port.
79.32.2 What You Need to Know
Read this section to know more about VLAN and how to configure the screens.
Table 347 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
LABEL
DESCRIPTION
Profile Name
Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the
Start
Address
and
End Address
fields.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
