Chapter 79 Networked AV Mode
XGS2220 Series User’s Guide
605
The following table describes the related labels in this screen.
79.35 VLAN Port Setup
Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click
SWITCHING
>
VLAN
>
VLAN Port Setup
to display the screen as shown.
Figure 452
SWITCHING > VLAN > VLAN Port Setup
Table 352 SWITHCING > VLAN > Static VLAN > Add/Edit
LABEL
DESCRIPTION
Active
Enable the switch button to activate the VLAN settings.
Name
Enter a descriptive name for the VLAN group for identification purposes. This name consists of up
to 64 printable ASCII characters. The string should not contain [ ? ], [ | ], [ ' ], [ " ] or [ , ].
VLAN Group ID
Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
Port
The port number identifies the port you are configuring.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control
Select
Normal
for the port to dynamically join this VLAN group using GVRP. This is the default
selection.
Select
Fixed
for the port to be a permanent member of this VLAN group.
Select
Forbidden
if you want to prohibit the port from joining this VLAN group.
Tagging
Select
Tx Tagging
if you want the port to tag all outgoing frames transmitted with this VLAN
Group ID.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
