ZyXEL Communications VSG-1200 V2, User Manual

Page: 47 / 282

VSG-1200 V2 User’s Guide
47 Chapter 3 The Web Configurator
3.7 Resetting the VSG
You can restore the device to the factory defaults in one of the following ways.
• The RESET button on the front panel of the VSG (press this button once). Use this
method for cases when the username and password of the VSG is not known (refer to
Section 2.2.1.5 on page 40 ).
• The web configurator (refer to Section 3.7 on page 47 ).
• The SMT (refer to Section 29.4 on page 200 ).
3.8 Restarting the VSG
Note: You must restart the VSG every time you change the system IP address or
upload a firmware or configuration file.
All unsaved changes will be lost once you restart the VSG.
In the Main Menu screen, click System Tools , Restart and click Apply .
Confirm Enter the new administrator password again for confirmation.
Supervisor Account This account allows you to view device status only.
Username Enter the user name for the supervisor account. The default is supervisor
Password Enter a new supervisor password. The default is supervisor .
Confirm Enter the new administrator password again for confirmation.
Super Subscriber
Account
Once you have configured the Internet connection settings on the VSG, you
can use this account to test the Internet connection through the VSG.
Super Subscriber Select Enable to activate this account.
Select Disable to deactivate this account.
Idle Timeout By default, the VSG automatically logs out a super subscriber after five minutes
of inactivity.
Enter a number (1 to 1440) to set the VSG to log out the super subscriber after
the specified inactivity timeout (in minutes).
Username Enter the user name for the account manager account. The default is super .
Password Enter a new account manager password. The default is super .
Confirm Enter the new administrator password again for confirmation.
Apply Click Apply to save the changes back to the VSG.
Table 3 System Tools: System Account (continued)
LABEL DESCRIPTION