16 | ©2017
Configuration
As soon as the device is switched on, the automatic link detection begins. You can
see this at the flashing
POWER
LED and later at the
DSL
LED.
The configuration of your gateway occurs via the Setup wizard. To complete this
step, you will need the personal login credentials that sere sent to you after you
ordered your Internet access.
After the
POWER
LED has turned solid green, enter the IP address
or
in the URL address field of your browser. Your computer needs to con-
nected to the gateway via the
LAN1
port for this purpose. You will now be asked
for the password to access the user interface. This can be found on the name-
plate at the bottom of the device.
L
NOTE
Please note down the password during the configuration. Without the access
credentials, you will no longer be able to start the user interface of the gateway.
The gateway would then need to be reset to its factory settings. All configured set-
tings would thus be lost in the process!
Now start the Setup wizard via the main menu on the left of the
user interface and follow the instructions.
L
NOTE
Since the automatic link detection can take up to 10 minutes, you will be informed
on launching the wizard whether this has already been completed. Please wait as
long as needed until this process has completed.
On the following
Internet Access
page, please select your provider and enter the
appropriate access data.
Confirming this with
Next
takes you to the
Internet Telephony
page. Here, under
VoIP Account Type
, select the entry
SIP Trunk
if you want to configure a point-to-
point connection and
SIP Account
if you want to configure a point-to-multipoint
connection. Enter the required data in the fields below. Then click
Next
.
L
NOTE
To enter passwords in the user interface, you can use the characters A-Z, a-z, the
digits 0-9 and the following special characters
! ? * @ # § $ % & ( ) _ + , - . : \ / < = >
You can then end the configuration on the
Summary
page by clicking
Apply
. This will return you to the main menu of your gateway user interface, where
you can configure further settings.
The successful completion of the Internet access configuration is signaled by a
steady green
WEB
LED.
Changing the connection type
A change between ADSL and VDSL recognizes the device fully automatic and no
manual interaction is required. Only the change between VDSL or ADSL and fiber
is not detected automatically and the device has to be reset to the factory default
settings and reconfigured. Consequently, please store your access data securely
even after the initial setup.
EN
EN
