ZyXEL Communications STB-1003, User Manual

Page: 31 / 98

Chapter 2 The Menu System
STB-1003 User’s Guide
31
2.3.3.3 Network: PPPoE
Select PPPoE in the Network menu. The following menu displays.
Figure 12 The Network: PPPoE Menu
The following table describes the labels in this menu that were not already described in table 7 .
2.3.4 The Advanced Setup: Firmware Upgrade Menu
Use this menu to get new firmware from the autoconfiguration server. You must be connected
to the network and have a valid autoconfiguration server address configured in the
Advanced
Setup: Network Setup menu’s ACS Server field (see Section 2.3.3 on page 29 ).
Select Firmware Upgrade from the column on the left of the screen. The following menu
displays.
Primary DNS Enter the IP address of the primary Domain Name Server. DNS
allows your STB to resolve domain names (such as zyxel.com ) into
IP addresses.
Secondary DNS Enter the IP address of the secondary (backup) Domain Name
Server.
Table 8 The Network: Static IP Menu
LABEL DESCRIPTION
Table 9 The Network: PPPoE Menu
LABEL DESCRIPTION
Mode Select PPPoE to use a Point-to-Point Protocol over Ethernet
service.
User Name Enter the username for your PPPoE account.
Password Enter the password for your PPPoE account.