ZyXEL Communications SAM1316-22, User Manual

Page: 307 / 464

Chapter 48 Alarm Commands
SAM1316-22 User’s Guide
307
48.7 Log Format
The following table describes the columns in the list.
48.8 Alarm History Show Command
Syntax:
ras> alarm history show [<severity>|all] [<alarm>|all] [<condition>|all]
[<sdate>|all] [<edate>|all] [for|rev] [detail]]
where
This command displays historic alarms by severity, alarm category, alarm
condition and/or dates.
Table 105 Log Format
LABEL DESCRIPTION
no
This is the index number of the alarm entry in this list display.
alarm
This is the category of alarms. eqpt represents equipment alarms. dsl
represents Digital Subscriber Line (DSL) alarms. enet represents
Ethernet alarms. sys represents system alarms.
condition
There is a condition code number for the specific alarm message and
a text description for the condition under which the alarm applies.
facility
This is the log facility (local1~local7) on the syslog server where the
system is to log this alarm. This is for alarms that send alarms to a
syslog server.
snmp
This displays “V” if the system is to send this alarm to an SNMP
server. It displays “-“ if the system does not send this alarm to an
SNMP server.
syslog
This displays “V” if the system is to send this alarm to a syslog server.
It displays “-“ if the system does not send this alarm to a syslog
server.
severity
This is the alarm severity level (critical, major, minor or info).
clearable
This displays “V” if the alarm clear command removes the alarm from
the system. It displays “-“if the alarm clear command does not
remove the alarm from the system.
<sdate> =
The start date, in
yyyy/mm/dd
format.
<edate> =
The end date, in
yyyy/mm/dd
format.
[for|rev] =
The displaying order. Use
for
to display in chronological
order starting from the oldest alarm. Use
rev
to display
in reverse chronological order starting from the most
recent alarm.
[detail] =
Display in-depth alarm information.