ZyXEL Communications SAM1316-22, User Manual

Page: 303 / 464

SAM1316-22 User’s Guide
303
C
H A P T E R
4 8
Alarm Commands
This chapter describes the alarm management commands.
48.1 Alarm Commands
Use these commands to view, customize and clear alarms. You can also set the
device to report alarms to an SNMP or syslog server that you specify.
48.2 General Alarm Command Parameters
The following table describes commonly used alarm command parameter
notation.
Table 104 General Alarm Command Parameters
NOTATION DESCRIPTION
<alarm>
Specify a category of alarms.
eqpt represents equipment alarms.
dsl represents Digital Subscriber Line (DSL) alarms.
enet represents Ethernet alarms.
sys represents system alarms.
all specifies every alarm category.
<severity>
Specify an alarm severity level (critical, major, minor, info or all).
Critical alarms are the most severe, major alarms are the second
most severe, minor alarms are the third most severe and info alarms
are the least severe.
<condition>
This is the text description for the condition under which the alarm
applies. Use the alarm tablelist to find alarm conditions.