ZyXEL Communications SAM1316-22, User Manual

Page: 299 / 464

Chapter 47 Command Examples
SAM1316-22 User’s Guide
299
An example is shown next.
47.3.2 Isolation Enable Command
Syntax:
ras> switch isolation enable
This command turns on the subscriber isolation feature.
47.3.3 Isolation Disable Command
Syntax:
ras> switch isolation disable
This command turns off the subscriber isolation feature.
47.3.4 Switch Isolation VLAN Delete Command
Syntax:
switch isolation vlan delete < vid >
where
This command turns off per-VLAN isolation for the specified VLAN.
Note: Per-VLAN isolation only works when the regular switch isolation feature is
disabled (see Section 47.3.3 on page 299 ).
The following example turns off per-VLAN isolation for VLAN 5.
Figure 137 Isolation Show Example
ras> switch isolation show
system isolation: enabled
system switch mode : stand alone
< vid > =
The VLAN ID [1 – 4094].
ras> switch isolation vlan delete 5
ras> switch isolation show
port isolation :disabled
isolated vlan list:
----
938