ZyXEL Communications SAM1316-22, User Manual

Page: 256 / 464

Chapter 41 Alarm
SAM1316-22 User’s Guide
256
41.5 Alarm Port Setup Screen
Use this screen to set the alarm severity threshold for sending SNMP traps or sys
logs in response to alarms on an individual port(s). The system sends SNMP traps
or sys logs if the alarm has a severity equal to or higher than the port’s threshold.
Facility The log facility (local1~local7) has the device log the syslog messages
to a particular file in the syslog server. Select a log facility
(local1~local7) from the drop-down list box if this entry is for sending
alarms to a syslog server. See your syslog program’s documentation
for details.
SNMP Select this check box to have the system send this alarm to an SNMP
server.
Syslog Select this check box to have the system send this alarm to a syslog
server.
Severity Select an alarm severity level (critical, major, minor or info) for this
alarm. Critical alarms are the most severe, major alarms are the
second most severe, minor alarms are the third most severe and info
alarms are the least severe.
Clearable Select this check box to allow administrators to use the management
interface to remove an alarm report generated by this alarm event
entry.
Select this check box to keep an alarm report generated by this alarm
event in the system until the conditions that caused the alarm report
are no longer present.
Apply Click Apply to save your changes to the SAM1316-22’s volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Close Click Close to exit the screen without saving your changes.
Table 97 Alarm Event Setup Edit (continued)
LABEL DESCRIPTION