A. Overview
The RGS200-12P Managed Rugged switch is designed for
supporting environmental hardening application. Managed switches
are easier to prioritize, partition, and organize user’s network,
providing a more reliable and better quality services.
B. Dimension Illustration
RGS200-12P
127,3
[5.0]
28,3
[1.1]
19,9 [0.8]
30,5
[1.2]
30,5
[1.2]
15,1
[0.6]
14,7
[0.6]
47,2
[1.9]
9,6 [0.4]
53,0 [1.4]
13,1 [0.5]
61,0 [2.4]
55,9 [2.2]
12,0 [0.5]
35,0 [1.4]
77,0
[3.0] 24,0
[0.9]
11,0
[0.4]7,0
[0.3]
7,0
[0.3]
11,0
[0.4]
25,0
[1.0]
154,0 [6.1]
C. DIN-Rail Mounting
Mounting step:
1. Screw the DIN-Rail bracket on with the bracket and screws in the
accessory kit.
2. Hook the unit over the DIN rail.
3. Push the bottom of the unit towards the DIN Rail until it locks in
place.
2
3
D. Wall Mounting
Screw the wall-mount brackets with screws in the accessory kit.
M4 SCREW
77,0
[3.0]
154,0 [6.1]
172,0 [6.8]
E. Connecting Power Terminal Block
The switch can be powered from two power supplies (input range
12V – 58V). Insert the positive and negative wires into V+ and V-
contacts on the terminal block respectively and tighten the
wire-clamp screws to prevent the wires from being loosened.
The DC power should be connected to a well-fused
power supply.
Input power should be within the range of 54~58VDC for PoE+
compliant, or 48-58VDC for PoE compliant.
Second Power Supply
First Power Supply
RGS200-12P Rugged Switch
Quick Start Guide
F. Alarm Relay and Ground
The alarm relay output contacts are in the middle of the DC terminal
block connector as shown in the figure below.
The alarm relay out is “Normal Open”, and it will be closed when
detected any predefined failure such as power failures or Ethernet
link failures.
The relay output with current carrying capacity of 0.5A @ 24 VDC
Extra Power System
Alarm System
Ground Connector
G. Console Connection
• DB9 connector connect to computer COM port
• Baud rate: 115200bps
• 8 data bits, 1 stop bit
• No Parity
• None flow control
H. Connect & Login to Managed Switch
1. Connecting to the Ethernet port (RJ45 Ethernet port) of Managed
Switch.
2.
Factory default IP: 192.168.1.1
3. Login with default account and password.
Username: admin
Password: 1234
Copyright © 2016 Zyxel Communications Corp. All Rights Reserved
EU Importer
Zyxel Communication A/S Generatorvej 8D, 2860 Søborg, Denmark.
http://www.zyxel.dk
US Importer
Zyxel Communications, Inc 1130 North Miller Street Anaheim, CA 92806-2001
http://www.us.zyxel.com
This equipment is intended to be used in a Restricted Access
Location, with access limited to SERVICE PERSONAL and USERS
authorized to be in that location.
