ZyXEL Communications RGS Series, User Manual

Page: 128 / 259

128
5.3.56 VLAN Configuration
Each page shows up to 99 entries from the VLAN table, default being 20, selected through the "entries per
page" input field. When first visited, the web page will show the first 20 entries from the beginning of the VLAN
Table. The first displayed will be the one with the lowest
VLAN ID found in the VLAN Table.
The "VLAN" input fields allow the user to select the starting point in the VLAN Table.
Object Description
Delete
Check to delete the entry. The designated entry will be deleted during the next save.
VLAN ID
The VLAN ID of the entry.
MLD Snooping Enabled Enable the per-VLAN MLD Snooping. Up to 32 VLANs can be selected for MLD
Snooping.
Querier Election Enable to join MLD Querier election in the VLAN. Disable to act as a MLD
Non-Querier.
Compatibility
Compatibility is maintained by hosts and routers taking appropriate actions depending
on the versions of MLD operating on hosts and routers within a network.
The allowed selection is
MLD-Auto
,
Forced MLDv1
,
Forced MLDv2
, default
compatibility value is MLD-Auto.
PRI
Priority of Interface.
It indicates the MLD control frame priority level generated by the system. These
values can be used to prioritize different classes of traffic.
The allowed range is
0
(best effort) to
7
(highest), default interface priority value is 0.
RV
Robustness Variable.
The Robustness Variable allows tuning for the expected packet loss on a link.
The allowed range is
1
to
255
, default robustness variable value is 2.
QI Query Interval.
The Query Interval is the interval between General Queries sent by the Querier.
The allowed range is
1
to
31744
seconds, default query interval is 125 seconds.
QRI
Query Response Interval.
The Maximum Response Delay used to calculate the Maximum Response Code
inserted into the periodic General Queries.
The allowed range is
0
to
31744
in tenths of seconds, default query response interval
is 100 in tenths of seconds (10 seconds).
LLQI Last Listener Query Interval.
The Last Listener Query Interval is the Maximum Response Delay used to calculate
the Maximum Response Code inserted into Multicast Address Specific Queries sent
in response to Version 1 Multicast Listener Done messages. It is also the Maximum
Response Delay used to calculate the Maximum Response Code inserted into
Multicast Address and Source Specific Query messages.
The allowed range is
0
to
31744
in tenths of seconds, default last listener query
interval is 10 in tenths of seconds (1 second).
URI
Unsolicited Report Interval.
The Unsolicited Report Interval is the time between repetitions of a node's initial report