Prestige 641 ADSL Internet Access Router
Bridging Setup
7-3
To set up Menu 11.3 - Remote Node Network Layer Options follow these steps:
Step 1.
In Menu 11.1, make sure the Bridge field is set to
Yes
.
Step 2.
Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select
Yes
and
press [
Enter]
to open Menu 11.3 - Network Layer Options.
Figure 7-2 Menu 11.3 - Remote Node Bridging Options
The following table describes the bridging-specific parameters in the Remote Node Profile and Network
Layers menus.
Table 7-2 P641 Remote Node Network Layers Menu Bridge Options
Field
Description
Bridge
Make sure this field is set to Yes.
Edit IP/IPX/Bridge
Press the space bar to change it to Yes and press Enter] to go to the
Network Layer Options Menu.
Ethernet Addr
Timeout (min)
In this field, enter the time (number of minutes) that you wish your
Prestige 641 to retain the Ethernet Addr information in its internal tables
while the line is down. If this information is retained, your Prestige 641
will not have to recompile the tables when the line is brought back up.
Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to
Menu 11.1. Then press [Enter] at the message [Press ENTER to Confirm…] to save your
configuration, or press [Esc] to cancel.
Menu 11.3 - Remote Node Network Layer Options
VPI/VCI (RFC1483 LLC/PPP/ENET ENCAP) :
VPI #= 1
VCI #= 1
IP Options :
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
IPX Options :
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Ethernet Addr Timeout(min)= 0