ZyXEL Communications P660HTW3 EE, Quick Start Manual

Page: 4 / 10

4
1. DSL : Use a telephone wire to connect your P-660HW-Tx v3’s DSL
port to a telephone jack (or to a splitter, if one is already installed).
2. ETHERNET : Use an Ethernet cable to connect a computer to an
ETHERNET port for initial configuration and/or Internet access.
3. POWER : Use the power adaptor provided with your P-660HW-Tx v3
to connect an appropriate power source to the POWER socket. Make
sure the power source is on.
4. Push in the POWER button. Look at the lights on the front panel.
• The POWER light blinks while your P-660HW-Tx v3 starts up and
stays on once it is ready. The DSL light is on when the P-660HW-
Tx v3 has a DSL connection, and the WLAN light is on when the
wireless LAN is ready. The INTERNET light is on when you are
able to access the Internet and blinks when the P-660HW-Tx v3 is
sending or receiving data.
• Each ETHERNET light stays on if the corresponding ETHERNET
port is properly connected and blinks when there is traffic.
If any of these lights are not on, check your connections, and inspect
your cables for damage. If the lights are still off, contact your local
vendor.
Status Page
1. In your browser, go to http://192.168.1.1.